p. 39 - Manual FA01274-EN - 11/2018 - © CAME S.p.A. - The contents of this manual may change, at any time, and without notice. Original instructions
Information
FW version
View the fi rmware version. Press the ENTER key.
Maneuvers counter ➡ [Total maneuvers] > [Partial maneuvers]
[Total maneuvers] = to view the gate's total number of maneuvers.
[Partial maneuvers] = to view the total number of maneuvers completed by the gate between maintenance
sessions.
Set maintenance
To set the number of gate maneuvers before performing maintenance jobs on the system.
This number can be set from [1x100] up to [250x100].
(e..g. 1x100 = 100 maneuvers; 100x100 = 10000 maneuvers)
When the set number is reached, the warning light connected to 10-5 will blink three times, twice every hour.
Maintenance reset
To reset the number of the gate's partial maneuvers in [Partial maneuvers].
Resets the maneuvers each time the system undergoes maintenance.
Change mode
To change the command of the operator oof an added user.
1. From the [Manage users] menu, select [Change mode]. Press the ENTER key.
2. Select the user for whom you want to change the command. Press ENTER.
3. Select the new command to associate to the user. Press ENTER.
4. Select [Confi rm? YES] and press ENTER to confi rm the new command.
Alternatively, you can change a user's command without using the < > keys. Just send a command from
the corresponding user and press ENTER to confirm.
Done
Change mode
Confirm? YES
User mode
Sequential
Change mode
One RADIO
Manage users
Change mode
To Next Page
Loading...
Need help?
General
