Important
• When storing printed documents on the Output Stacker, always use it in position (1). If you do not, printed documents may
not be dropped into the Output Stacker, and the printed surface may become soiled.
• The Output Stacker can hold one sheet. When printing multiple pages, remove each sheet after it is printed.
• Before using the Output Stacker, remove the Rewind Spool. If you do not, it may prevent printed documents from being held
correctly, and they may be scratched.
• The Output Stacker can hold roll paper up to 84 inches (2133.6 mm) long. When printing longer documents, adjust the stack-
er for ejection in front or use the Media Take-up Unit (option).
The Output Stacker locks into position if you lift it to position (1) or (2). To lower the Output Stacker, lift the front Basket
Rod lightly to release the lock, and then lower the stacker.
Using the output stacker for ejection in front
You can also set the stacker to the following position when printing banners or when printing on delicate paper.
iPF9400
Using the Output Stacker
User's Guide
Handling and Use of Paper Output Stacker
565
To Next Page
Loading...
Need help?
General
Weight and Dimensions
