Cause Corrective Action
When Detect Mismatch in the Control Panel menu
is set to Pause, the type of paper loaded does not
match the type specified in the printer driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
2.
Replace the loaded paper with paper of the type and size you have specified in the
printer driver.
(See "Loading and Printing on Rolls.") →P.22
(See "Loading and Printing on Sheets.") →P.25
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
You tried to print a test pattern for printer adjustment
on several sheets, but sheets of different types of
paper were used.
When printing a test pattern for adjustment, use sheets of the same type of paper, in the
required quantity. Replace the paper as follows and perform adjustment again.
1.
Lift the Release Lever and stop printing.
2.
Replace the paper.
(See "Loading and Printing on Sheets.") →P.25
3.
Execute adjustment again from the control panel menu.
When Detect Mismatch in the Control Panel menu
is set to Warning, the type of paper loaded does not
match the type specified in the printer driver.
You can continue to print, but note that this error may cause problems in the printing
results.
The paper is too small.
The paper is too small.
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is
set to Pause or Hold Job, paper smaller than the size
specified in the printer driver is loaded.
Press ▲ or ▼ to select Print, and then press the OK button to resume printing.
However, note that this error may cause paper jams and affect the printing quality.
Adjust the paper size setting in the printer driver to match the size loaded in the printer
as follows.
1.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
2.
Change the paper size setting in the printer driver to the size loaded in the printer
and try printing again.
Replace the loaded paper with paper of a size that matches the size setting in the
printer driver as follows.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button to stop print-
ing.
2.
Replace the loaded paper to match the settings in the printer driver and try printing
again.
(See "Loading and Printing on Rolls.") →P.22
(See "Loading and Printing on Sheets.") →P.25
When Detect Mismatch in the Control Panel menu is
set to Warning, paper smaller than the size specified
in the printer driver is loaded.
You can continue to print, but note that this error may cause problems in the printing
results.
The paper is too small.
The paper is too small.
"Replace paper with A4/LTR (vertical) or larger"
Cause Corrective Action
The loaded paper is too small.
(When you have attempted to print a test print sheet
or other printer status information.)
Replace the paper with paper of A4/Letter (vertical) size or larger as follows.
1.
Press ▲ or ▼ to select Change Paper, press the OK button, and remove the paper.
(See "Removing Sheets.") →P.560
2.
Switch to paper A4/Letter (vertical) or larger.
(See "Loading and Printing on Sheets.") →P.25
iPF9400
The paper is too small.
User's Guide
Error Message Messages regarding paper
911
To Next Page
Loading...
Need help?
General
Weight and Dimensions
