Using imagePROGRAF Printmonitor (Mac OS)
Manage jobs as needed on the Driver sheet. For details, refer to the imagePROGRAF Printmonitor help file.
Managing Pending Jobs (Printing or Deleting Jobs on Hold)
Managing Pending Jobs (Printing or Deleting Jobs on Hold)
If the type or size of paper loaded does not match the settings in the print job received when you have set Detect Mis-
match to Hold Job in the Control Panel menu, the print job is held on the printer as a pending job in the job queue.
Manage held jobs such as these as follows.
These operations are available from the Control Panel or in RemoteUI, imagePROGRAF Status Monitor, and image-
PROGRAF Printmonitor.
Note
• As long as you do not manage held jobs from the Control Panel, imagePROGRAF Status Monitor, or imagePROGRAF Print-
monitor, they will remain in the job queue. In this case, the printer processes the next job in the queue without pausing.
• To print held jobs, replace the loaded paper with the paper specified in the print job.
(See "Loading Rolls in the Printer.") →P.533
(See "Loading Sheets in the Printer.") →P.555
Using the Control Panel
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Job tab (
).
"There are held jobs." is displayed if jobs are being held.
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Job Menu menu is displayed.
3
Press ▲ or ▼ to select Print Job, and then press the OK button.
iPF9400
Managing Pending Jobs (Printing or Deleting Jobs on Hold)
User's Guide
Print Job Management Basic Print Job Operations
761
To Next Page
Loading...
Need help?
General
Weight and Dimensions
