After you execute Repl. maint cart and replace the Maintenance Cartridge, a message will appear on the Display
Screen requesting you to replace the Shaft Cleaner. Select Yes and press the OK button. When a message requests
you to open the Top Cover, go to step 5.
1
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-
lect the Settings/Adj. tab (
).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the
OK button.
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Maintenance, and then press the OK button.
4
Press ▲ or ▼ to select Repl. S. Cleaner, and then press the OK button.
The Carriage moves. When it finishes moving, instructions are displayed on the Display Screen.
5
Open the Top Cover.
Note
• If you do not respond within two minutes, shaft cleaner replacement is canceled. In this case, repeat the procedure.
6
Hold the Shaft Cleaner on the right side of the Carriage
by the grips (a) and pull it to the right to remove it.
iPF9400
Replacing the Maintenance Cartridge
User's Guide
Maintenance and Consumables Maintenance Cartridge
857
To Next Page
Loading...
