Setting Page
119
• If all or part of the image appears to have a white glow, there is a possibility that a wall (even a wall not in the image) is reflecting the
infrared lighting. If this occurs, please adjust the camera angle.
• If you use the Sunshade Cover (sold separately) in conjunction with infrared illumination, switching between day/night using [Day/Night]
> [Auto] may not be possible due to the angle of the lens. In this case, adjust the angle of the lens (please refer to "Installation Guide"), or
configure [Switch Day/Night] using [Timer] (P. 168).
[Infrared Light Level]
Sets the infrared illumination strength when [Day/Night Operation] is selected in [Use Infrared].
[Infrared Light Level] can only be set when [Exposure] is set to [Manual].
To Next Page
Loading...
