Canon VB-R13 - Linked Event Operation Examples

202
[Sound Clip]
Select the sound clip when [Audio Playback at ON Event] or [Audio Playback at OFF Event] has been set to [Enable].
You must register the sound clip with [Video and Audio] > [Audio] (P. 148) beforehand.
[Volume]
Enter the volume for the sound clip.
Linked Event Operation Examples
This shows linked event status examples according to the ON/OFF combinations for Event 1 and Event 2.
In the examples below, [Event Gap] is four seconds and each cell in the graphs below represents one second.
 [Event Linking Method] Set to [OR]
Only One Event ON
Both Events ON
 [Event Linking Method] is Set to [AND], [Event Order] is Specified
This shows examples when [Event Order] is set to [Event 1 -> 2].
When [Event Order] is set to [None] and [Event Linking Method] is set to [AND], linked events will be as in the
examples, even if Event 1 and Event 2 are switched.
When Events Occur in Order 1 -> 2
When Events Occur in Order 2-> 1 -> 2
ON
Event 1
Event 2
Consolidated
State
OFF
ON
OFF
ON
OFF
ON
Event 1
Event 2
Consolidated
State
OFF
ON
OFF
ON
OFF
ON
Event 1
Event 2
Consolidated
State
OFF
ON
OFF
ON
OFF
ON
Event 1
Event 2
Consolidated
State
OFF
ON
OFF
ON
OFF
Both events are ON, but their order of occurrence is
incorrect. Therefore, a linked event does not occur here.