Setting Page
219
[Network Settings]
If you set this to [Save], the following settings are retained when initializing.
• Administrator Name
• Password
• Network Settings
• Time Zone
• Certificates
• Private Key
If you set this to [Do not save], the above settings are also initialized.
Since the administrator account is also initialized, you will become unable to connect to the camera. Use the Camera
Management Tool to configure the initial settings (P. 38).
[Revert to Initial Settings]
The initial settings are restored according to the selection in [Network Settings] after rebooting.
• It is recommended that you back up each current setting before you click [Exec] in [Restore Default Settings].
• The camera can also be restored to factory default settings using the reset switch. Note, however, that this will reset all camera settings
to factory default settings except for date and time (P. 245).
Caution
• You must not turn off the camera while [Restore Default Settings] is in operation. Turning off the camera at this stage
may result in disabling its ability to boot correctly.
• Once [OK] is clicked, you can no longer stop the process of restoring the default settings.
To Next Page
Loading...
