SECTION 00 -- GENERAL INFORMATION -- CHAPTER 1
00-6
DANGER
To prevent injury to bystanders, this mower is
not intended for roadside or municipal mowing.
This mower is intended for agricultural use only.
Left and right are determined by standing behind the
unit, looking in the direction of travel.
The product identification number plate, 1, for the
Models MDX71/81/91 is located on the left side of the
main frame.
19986828
1
1
HARDWARE TORQUE VALUES
Check the tightness of hardware periodically.
Use the following charts to determine the correct
torque when checking, adjusting or replacing
hardware on the tractor.
IMPORTANT: DO NOT use the values listed in the
charts if a different torque value or tightening
procedure is specified in this manual for a specific
application. Torque values listed are for general use
only.
Install a lock washer on all bolts unless a locknut or
jam nut is specified.
Install a flat washer at all slotted holes unless a
carriage bolt or flanged head bolt is specified.
Make sure fastener threads are clean and not
damaged.
NOTE: A torque wrench is necessary to properly
torque hardware.
To Next Page
Loading...
