SECTION 00 -- GENERAL INFORMATION -- CHAPTER 1
00-28
STORING THE MOWER
1. Clean the mower. Grease all fittings.
2. Drain the oil from the bevel gearbox and all mod-
ules and refill with new, clean oil to the correct
level. Run the mower for a few minutes.
3. Store the cutter bar in the operating position.
4. Remove the drive belt and store it in a dry place.
5. Clean the cutter bar rusted area and touch up
with factory paint. Spray cans are available from
your authorized dealer.
To Next Page
Loading...
