EasyManua.ls Logo

CERUS CI-007-P2 - Communication Group [Com]

Default Icon
137 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 6 - Parameter Description
6-38
6.8 Communication Group [COM]
The communication option card manual provides a
detailed description of the installation, wiring and
set-up procedures.
1)**+B'1
COM-00 allows
jumping to any
parameter in COM group without scrolling to it.
Press [ENTER] key and put a desired parameter
code by using [SHIFT] and [UP]/[DOWN] keys.
When [ENTER] key is pressed again, the desired
parameter will be on the display.
1)*+ !;"
COM-01 shows what
type of communication
board is installed. There are five types of
communication boards: RS-485, DeviceNet,
ProfiBus, BACnet and LonWorks
1)*+ !;"1! "
COM-03 has four
selections for VFD
control via communication card: None, Command,
Freq and Cmd+Freq.
None- The communication provides only
monitoring of the VFD parameters but no control.
Command- The communication provides
monitoring of the VFD parameters and start/stop
control. The VFD speed control is based on SET-10
selection.
Freq- The communication provides monitoring of
the VFD parameters and speed control. The VFD
start/stop control is based on SET-09 selection.
Cmd+Freq- The communication provides
monitoring of the VFD parameters, start/stop and
speed control.
1)*.+ !;""!
COM-03 shows the
communication board
version number.
1)*+%1$
COM-10 allows to set
MAC ID from 0 to 63.
1)+;' 
COM-11 allows to set
Baud rate: 125, 250 or
500kbps.
1)+'$! !
COM-10 allows to set
Out Instance: 20, 21,
100 or 101.
1).+& $!' $! !
COM-13 allows to set
DeviceNet input
instance number: 70, 71, 110 or 111.
1)3+1 !  !$'8"
COM-17 allows to set
station ID number from
0 to 63.
1)*+">;'%1$'8"
COM-20 is a Profibus
station ID number from
1 to 127.
1).*+' ' '8"
COM-30 allows to set
output number from 0
to 8.
1).A.4+' ' %"<#?=
COM-31 through
COM-38 are
parameters for eight communication output address
settings.
COM
Jump Code
00 2
COM Opt
B/D
01 BACnet
COM Opt
Mode
02 None
COM Opt Version
03
Ver x.x
COM In Instance
13
70
COM Station ID
17
1
COM Profi MAC ID
20
1
COM Output Num
30
3
COM Output1
31
000A
COM MAC ID
10
63
COM Baud Rate
11
125 kbps
COM OutInstance
12
21

Table of Contents

Related product manuals