WARNING
Do not remove VFD cover for wiring or periodic inspections while
power is applied or the unit is in operation.
Otherwise, electric shock could occur to the exposed terminals and bus bars.
Wiring and periodic inspections should be performed at least 10
minutes after disconnecting the input power with DC link voltage
below 30VDC.
Otherwise, electric shock could occur.
Operate VFD and control devices with dry hands.
Otherwise, electric shock could occur.
Do not use VFD if power or motor cable is damaged.
Otherwise, electric shock could occur.
CAUTION
Install VFD on a non-flammable surface. Do not place flammable
materials nearby.
Otherwise, fire could occur.
Disconnect the input power if VFD has been damaged.
Otherwise, it could result in a secondary accident and fire.
Do not touch VFD after shutting down or disconnecting it. It can
remain hot for a few minutes.
Otherwise, bodily injuries such as skin-burn or damage could occur.
Do not apply power to a damaged VFD or to VFD with missing parts.
Otherwise, electric shock could occur.
Do not allow lint, paper, wood chips, dust, metallic chips or other
foreign material into the drive.
Otherwise, fire or accident could occur.
To Next Page
Loading...