Chen Hsong CDC-2000 - Menitor Operational Keys

CDC-2000 Operational Manual
2.26.
TEMPERATURE CURVE OF
T3---------------------------------------------------------------------------79
2.27.
TEMPERATURE CURVE OF
T4---------------------------------------------------------------------------80
2.28.
TEMPERATURE CURVE OF
T5---------------------------------------------------------------------------81
2.29.
TEMPERATURE CURVE OF
------------------------------------------------------------------------------82
2.30.
TEMPERATURE CURVE OF
TC--------------------------------------------------------------------------83
2.31.
MOULD NUMBER SETTING
-------------------------------------------------------------------------------84
2.32.
SPARE COUNTER SETUP
-----------------------------------------------------------------------------------88
2.33.
QUALITY RECORD CHART
--------------------------------------------------------------------------------90
2.34.
SPC DISPLAY CHART
---------------------------------------------------------------------------------------92
2.35.
QUALITY CURVE DISPLAY CHART
-----------------------------------------------------------------------93
2.36.
PROGRAM MONITORING
---------------------------------------------------------------------------------94
2.37.
RELAY MONITORING
--------------------------------------------------------------------------------------95
2.38.
INPUT NODE MONITORING OF COMPUTER
-------------------------------------------------------------99
2.39.
OUTPUT NODE MONITORING
----------------------------------------------------------------------------111
2.40.
FUNCTION SELECTION SETUP
--------------------------------------------------------------------------123
2.41.
SPARE SPEED AND PRESSURE SETUP
------------------------------------------------------------------127
2.42.
SPARE COUNTER SETUP
---------------------------------------------------------------------------------133
2.43.
SPARE TIMER UNIT DESCRIPTION
---------------------------------------------------------------------137
2.44.
RECORED CHART OF BREAKDOWN
--------------------------------------------------------------------141
2.45.
RESTORING OPERATIONAL CHART OF OPTICAL METEN
-------------------------------------------143
2.46.
PERIPHERAL AND CIPHER SETTING CHART
----------------------------------------------------------145
2.47.
DISPLAY CHART OF PRODUCTIVE INFORMATION
---------------------------------------------------147
2.48.
RECORD CHART OF PARAMETRIC VARIATION
-------------------------------------------------------148
3 . ALARM INFORMATION OVERVIEW-------------------------------------------------------------151
3.1."001
EXCHANGE THE BATTERY OF COMPUTER UPS
"-----------------------------------------------151
3.2."003
CHECK SPLIT NUTS
'
POSITION
"------------------------------------------------------------------151
3.3."004
ERROR OF THE GEARING POSITION
"------------------------------------------------------------151
3.4."006
ERROR FOR THE FEEDING OF EJECTOR
"-------------------------------------------------------151
3.5."009
TEMPERATURE IS BELOW THE SETTING VALUE
"----------------------------------------------152
3.6."013
LARGE
CYLINDER
EXCEEDS THE DISTANCE
-------------------------------------------------153
3.7."014
THE VOLUME OF LUBRICATIVE TANK IS TOO LOW
"------------------------------------------153
3.8."015
CLAMPING DISTANCE DOES NOT STOP
"--------------------------------------------------------154
3.9."017
THE CLAMPING MOTOR EXCEEDS ITS LOAD
'
S LIMITATION
"-------------------------------154
3.10."018
THE BACKWARD SAFE DOORS DON
'
T YET BE CLOSED
"------------------------------------154
3.11."019
THE FORWARD SAFE DOORS DON
'
T YET BE CLOSED
"--------------------------------------154
3.12."020
LIMIT SWITCH ERROR OF EJECTOR FEEDING
"---------------------------------------------154
3.13."021
ADJUSTING MOULD EXCEEDS THE MINIMUM SIZE
"---------------------------------------155
3.14."022
ADJUSTING MOULD EXCEEDS THE MAXIMUM SIZE
''--------------------------------------155
II