Chen Hsong CDC-2000 - Page 3

CDC-2000 Operational Manual
3.15."023
ERROR OF COUNTER SWITCH FOR ADJUSTING MOULD
"---------------------------------155
3.16."027
TURN OFF THE POWER TO RESTART
"----------------------------------------------------------155
3.17."028
THE MOTOR OF PUMP EXCEEDS THE LOAD
"-------------------------------------------------156
3.18."029
NOT BE NORMAL FOR MOTOR STARTING
"----------------------------------------------------156
3.19."031
TEMPERATURE OF CYCOIC OIL IS TOO LOW
"-----------------------------------------------156
3.20."035
BAD VOLUMES OF PRODUCTION ARE TOO HIGH
"-------------------------------------------156
3.21."036
CHECK CORE PULL
2
THROUGH THE LIMIT SWITCH
"--------------------------------------157
3.22."037
CHECK LIMIT SWITCH OF LARGE
CYLINDER"---------------------------------------------158
3.23."038
MOVING DISTANCE
’
S ERROR OF LARGE
CYLINDER"-------------------------------------158
3.24."039
CHECK LIMIT SWITCH OF UNSCREW
"---------------------------------------------------------159
3.25."041
PRODUCTS ARE REACHED THE SETTING
"-----------------------------------------------------160
3.26."042
CHECK LIMIT SWITCH OF CLAMPING MOULD
"-----------------------------------------------161
3.27."043
CHECK LIMIT SWITCH OF CORE PULL
1 "-----------------------------------------------------161
3.28."044
CHECK LIMIT SWITCH OF ROTATIONAL PLATE
"---------------------------------------------162
3.29."046
ROBOTIC ARM DOES NOT COME BACK INITIAL POSITION
"---------------------------------162
3.30."047
CHECK THE OBTAINED PRODUCT BY ROBOTIC ARM
"---------------------------------------163
3.31."048
ERROR FOR THE PRODUCT CONFIRMATION SIGNAL
"---------------------------------------163
3.32."049
THE SENSOR OF ELECTRONIC EYE IS COVERED
"--------------------------------------------164
3.33."050
THE CLAMPING DESTANCE HAS STOPPED
"---------------------------------------------------164
3.34."051
THE OPENING MOULD HAS STOPPED
"---------------------------------------------------------165
3.35."052
THE OPENING MOULD JAS NOT YET STOPPED
"----------------------------------------------165
3.36."053
THE DISTANCE OF EJECTOR HAS STOPPED
"--------------------------------------------------165
3.37."054
THE BACKWARD DISTANCE OF EJECTOR HAS STOPPED
"-----------------------------------165
3.38."055
THE DISTANCE OF PLASTICIZING HAS STOPPED
"--------------------------------------------165
3.39."056
THE UNSCREW HAS STOPPED
"------------------------------------------------------------------165
3.40."057
CHECK THE LIMIT SWITCH FOR NOZZLE ADVANCE
"----------------------------------------165
3.41."058
THE SAFE COVER OF NOZZLE HAS NOT YET CLOSED
"---------------------------------------166
3.42."059
THE NOZZLE IS OPPILATED
"---------------------------------------------------------------------166
3.43."060
THE PLASTICIZING VOLUME IS NOT ENOUGH OR TOO MUCH
"-----------------------------167
3.44."061
NOT NORMAL CHECKING FOR SAFE DOOR
"---------------------------------------------------167
3.45."065
THE HOPPER IS NULL OR OPPILATED
"---------------------------------------------------------167
3.46."066
THE PRODUCTS ARE REACHED THE SETTING
"-----------------------------------------------168
3.47."067
THE BAD PRODUCTS ARE TOO MANY
"---------------------------------------------------------168
3.48."068
THE CYCLIC TIME IS TOO LONG
"--------------------------------------------------------------169
3.49."071
LUBRICATION
"------------------------------------------------------------------------------------170
3.50."072
CLEAN THE MOULD
"-----------------------------------------------------------------------------171
3.51."079
ERROR OF EJECTOR ADVANCE
"----------------------------------------------------------------172
3.52."080
RESTART THE SAFE DOOR
"----------------------------------------------------------------------174
III