Video Pattern Generator 2238 User’s Manual
2-10
will go to the specified program directly. (Ex. Input 555 and it will go to Program #555.)
Touch to enter into Run Mode. Select a program in this mode and output.
Touch to enter into Edit Mode. Select a program in this mode and output.
Zone B: Output control
Touch to start output. Touch it again during output or press . to pause
the program output.
When outputting a program, use the rotary knob to select next sequence by turning it
clockwise and counterclockwise to select previous sequence.
Touch to stop output.
Touch to enable or disable the R, G, B output.
Touch to enable or disable the inverse output.
Zone C: Program preview
1. SEQ no.
2. DELAY time
3. Output slot
4. Output pattern
See section 2.4.2 for editing the sequence.
2.4.2 Steps for Editing a Sequence
Touch to enter into sequence editing mode, and the LCD is shown as below.
To Next Page
Loading...