ChroMate™ ChroMate™ Operator’s Manual Doc. 4300 Rev. E 19
3.4 Instrument Check Out
Follow the instructions under the Instrument Setup & Software Installation section to
ensure that the ChroMate Manager software is installed and the computer and the 4300
Chromate instrument are powered on.
NOTE: If it is necessary to view / adjust the communication port settings of the computer
and the ChroMate instrument refer to the instructions found under Section 6.2 - COM
Port Settings.
When the 4300 ChroMate instrument powers up, note the following actions:
The instrument annunciates a beep sound
The fan and the lamp power on
The LED power indicator will light (light will flash/pulse)
The instrument will perform an initialization process and annunciate three short
beeping sounds signaling it is operational
If the instrument powers up, but the actions described above do not occur, check the
USB cable connections and COM port settings.
To Next Page
Loading...