Circutor CVM-A1500 User Manual

6�3�10�- DEVICE CONFIGURATION VARIABLES
The following functions are implemented for these variables:
Function 0x04: reading registers.
Function 0x10: Writing multiple registers.
Note: The programming values must be written in hexadecimal.
It is necessary to change the screen when a setup change is made for communi-
cations in order for the changes take effect in the display.
6�3�10�1�- Date and time
These parameters occupy 1 register each.
Table 45:Modbus memory map: Conguration variables (Date and Time).
Date and Time
Configuration variable Address Valid data window Default value
Year 283C 2013 to 2076 -
Month 283D 1 to 12 -
Day 283E 1 to 31 -
Time 283F 0 to 23 -
Minutes 2840 0 to 59 -
Seconds 2841 0 to 59 -
Note: The 6 registers must be written at once (as a group), otherwise it will respond with an
error.
Note: Once the time is set for the rst time, it will not be modiable from the equipment setup.
Date and time reprogramming is controlled by the embedded PowerStudio system.
To modify the date and time, you must access the conguration web page http://xxx.xxx.xxx.
xxx/html/setup.html. Where xxx.xxx.xxx.xxx is the assigned IP address to the equipment.
6�3�10�2�- Time zone
These parameters occupy 1 register each.
Table 46:Modbus memory map: Conguration variables (time zone).
Local time conguration
Configuration variable Address Valid data window Default value
Conguration of local time 2A9E Table 32 0
Time 2A9F
0: Winter
1:Summer
0
Note: The 2 registers must be written at once (as a group), otherwise it will respond with an
error.
Table 47: Conguration of local time
Local time parameter
Local time Value Local time Value
UTC+1 0x0000 UTC-11 0x000C
UTC+2 0x0001 UTC-10 0x000D
241
Instruction Manual
CVM-A1000 - CVM-A1500

Circutor CVM-A1500 Specifications

General

Brand	Circutor
Model	CVM-A1500
Category	Measuring Instruments
Language	English