Circutor CVM-A1500 - Page 349

8.3.- EXPANSION MODULES UPDATE
The update les are:
Table 179:Expansion modules update le.
Model Expansion modules update le
Transistor digital inputs/outputs
Relay Digital Inputs/Outputs
rmware_digi.bin
Analogue Inputs/Outputs rmware_analog.bin
Modbus TCP (Bridge) communications rmware_modbus_ip.bin
Modbus TCP (Switch) communications rmware_mtcp_switch.bin
LonWorks communications rmware_lonworks.bin
Probus communications rmware_probus.bin
MBus communications rmware_mbus.bin
Follow the steps below to update the device software:
1�- Replace the new le, Table 179, with the le in the microSD card.
2�- Insert the microSD card in its slot.
3�- Connect the device to the power supply.
The device scans the modules connected to it and looks to see whether there is a new update
for each of them.
If there is, the updating process may take around 7 minutes.
The updated information on the modules is displayed in the expansion modules section of the
information menu, “5.6.3.- EXPANSION MODULES.”
Figure 407:Expansion modules information screen�
The update les are not deleted automatically from the microSD card. This is in case you
want to add a new module afterwards and want it to be updated with the same version of the
modules already installed.
349
Instruction Manual
CVM-A1000 - CVM-A1500