Cisco 12000 - Editing an Existing ATM Interface Profile; Deleting an Existing ATM Interface Profile

7-6
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 7 Interface Profiles
Creating an ATM Interface Profile
Editing an Existing ATM Interface Profile
To edit an existing ATM Interface profile, proceed as follows:
Step 1 Choose the Cisco 12000/10720 Manager>Configuration>ATM>Configuration Profile option from
an ATM interface object. See Table 7-2 on page 7-2 for information on which objects allow you to launch
the ATM Interface Configuration Profile window.
Step 2 Choose the profile you wish to edit from the list of existing profiles displayed in the ATM Interface list
at the left of the window (see Figure 7-2).
Step 3 Edit the parameters displayed in the Configuration (1) tab, as required.
Step 4 Choose File > Save to save the changes made to the service profile.
Step 5 Choose File > Close to close the window.
Deleting an Existing ATM Interface Profile
To delete an existing ATM Interface profile, proceed as follows:
Step 1 Choose the Cisco 12000/10720 Manager>Configuration>ATM>Configuration Profile option from
an ATM interface object. See Table 7-2 on page 7-2 for information on which objects allow you to launch
the ATM Interface Configuration Profile window.
Step 2 Choose the Edit > Delete Profile. Choose the profile you wish to delete from the list displayed. A
Deletion Prompt window appears (see Figure 7-4) for you to confirm that you wish to delete the selected
profile.
Figure 7-4 Deletion Prompt Window
Step 3
Click Yes to delete the selected profile or click No to close the window without deleting the profile.
When a profile is deleted it disappears from the list of existing profiles displayed in the ATM Profile list
at the left of the window.