Cisco 12000 - Disassociating a Tofab Policy from a Line Card; Changing the Association of a Tofab Policy

11-37
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 11 Layer 3 QoS
WRED Rx Configuration
Step 2 Choose the Chassis and Module to associate the ToFab policy from the list box displayed at the left of
the window. More than one Chassis or Module can be selected at a time.
Step 3 Choose the ToFab policy in the available ToFab policy list.
Step 4 Click Associate
Disassociating a ToFab Policy from a Line card
To disassociate a ToFab policy from a line card, proceed as follows:
Step 1 Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
choose Cisco 12000/10720 Manager>Configuration>ToFab>WRED Rx Configuration to launch the
WRED Rx Configuration window. Refer Table 11-1 on page 11-2 for information on which objects
allow you to launch the WRED Rx Configuration window.
Step 2 Choose the Chassis and Module from the list boxes at the left of the window to which the ToFab policy
is associated.
Step 3 Click Disassociate
Changing the Association of a ToFab Policy
To change the association of a ToFab policy to a line card, proceed as follows:
Step 1 Launch the Map Viewer, choose the Layer3QoSView. Right click on the WRED-MDRR object and
choose Cisco 12000/10720 Manager>Configuration>ToFab>WRED Rx Configuration to launch the
WRED Rx Configuration window. Refer Table 11-1 on page 11-2 for information on which objects
allow you to launch the WRED Rx Configuration window.
Step 2 Choose the Chassis and Module from the list boxes at the left of the window to which a ToFab policy
is associated.
Step 3 Choose the ToFab policy that you want to associate.
Step 4 Click Associate
Note If a ToFab policy was previously associated with the interface, it is removed and the new ToFab
policy is associated.