Cisco 12000 - Adding an OSPF Process

14-49
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 14 Routing
OSPF Configuration
Adding an OSPF Process
This section explains the procedure to add an OSPF process to the device. To add an OSPF process,
proceed as follows:
Step 1 Open the OSPF configuration window. See “Viewing the OSPF Configuration Window” section on
page 14-47 for further details.
Step 2 Enter an OSPF process id in the Process ID textbox.
Step 3 Click on the Add OSPF Process button. An action report appears.
Figure 14-32 Action Report
Note The number of OSPF processes that can be created on a device depends on the number of
interfaces (with IP address) present on the device.