Cisco 12000 - Use of Telecom Graphics Objects

2-7
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 2 Concepts
Cisco 12000/10720 Router Manager Objects and Interfaces
• VLAN—Domain, VLAN, sub-interface objects. VLAN sub-interfaces can be configured on
Ethernet interfaces.
Table 2-3 describes the management functions for Layer 3 QoS logical configurations.
Table 2-4 describes the management functions for ATM logical objects.
Table 2-5 describes the management functions for VLAN objects.
Use of Telecom Graphics Objects
Cisco EMF uses Telecom Graphics Objects (TGO) in the Map Viewer application. TGO is a
TeleManagement Forum (TMF) sponsored initiative to provide standard graphical representations for
network topology maps.
A TGO displays additional information icons on top of the existing object icons displayed in Map
Viewer. The additional icons indicate a variety of information (for example, information on the state of
the object or event status information). Figure 2-2 provides an example of a TGO.
Table 2-3 Layer 3 QoS Logical Objects
Logical Object Management Functions
WRED:
CoS queue groups
ToFab Policies
Create, configure, apply, modify, delete and remove CosQ groups, WRED
ToFab and CAR objects.
CAR:
CAR policies
CAR access lists
Software: VRF Policies Create, configure, apply(to an interface) and remove(from device and
interface) VRF Policies
Table 2-4 ATM Logical Objects
Logical Object Management Functions You Can Perform
PVC
SVC
Upload, sync, create, configure, manage, and delete/connect/disconnect on
main or sub-interfaces. Status information can be collected and displayed
for PVC objects only.
Table 2-5 VLAN Objects
Logical Object Management Functions You Can Perform
Domain,
VLAN
VLAN sub-interfaces
Create and delete on Domain objects. Create, configure, manage, and delete
on VLAN and sub-interfaces.