8-25
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
SRP Interface Side Configuration
Step 3 Click on the Alarms tab, if required.
Figure 8-10 SRP Side Configuration window—Alarms tab
Configuring a SRP Side
To configure a SRP Side, proceed as follows:
Step 1 Launch the SRP Interface Side Configuration window. Refer to Table 8-2 on page 8-2 for information
on which objects allow you to launch the SRP Interface Side Configuration window.
Step 2 Choose a Chassis, Module, SRP Interface and SRP Side from the lists displayed at the left side of the
window.
Step 3 Edit the parameters displayed in the General and Alarm tabs, as required. See “SRP Interface Side
Configuration Window—Detailed Description” section for further details.
Step 4 Click Save to save your configuration changes.
To Next Page
Loading...
