CHAPTER
9-1
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
9
Interface Status
This chapter describes how to view status information for each of the interfaces on the Cisco device
being managed using the Cisco 12000/10720 Router Manager application.
This chapter contains the following information:
• Interfaces and Related Technology-Specific Windows
• Launching the Interface Status Windows
• Generic Interface Status
• ATM Interface Status
• ATM Interface Faults
• DS3/E3 Interface Status
• SONET Interface Status
• SRP Interface Status
• SRP Side IPS Status
• SRP Topology Map
Interfaces and Related Technology-Specific Windows
Interfaces on line cards can support multiple technologies. Status windows are technology-specific. For
example, a DS-3 interface supports two technologies: Generic and DS-3. Therefore, if you wish to view
the status of a DS-3 interface, you must view two windows: the Generic Interface Status window and the
DS-3 Interface Status window.
This process is also applicable to ATM, Ethernet, POS or SRP interfaces. The following table outlines
which technology-specific status windows apply to each interface type.
Table 9-1 Interface Types and Status Windows
Interface Type Technology-Specific Status Window
DS-3 Generic and DS-3
ATM Generic, ATM and SONET
Ethernet Generic
POS Generic and SONET
To Next Page
Loading...
