Cisco 12000 - Configuring an ATM Interface

8-7
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
ATM Interface Configuration
The ATM Interface Configuration window appears:
Figure 8-2 ATM Interface Configuration Window—Configuration 1 Tab
Step 2
Choose a Chassis, Module, and ATM Interface from the lists displayed at the left of the window.
Configuring an ATM Interface
To configure an ATM Interface, follow these steps:
Step 1 Open the ATM Interface Configuration window. See “Viewing the ATM Interface Configuration
Window” section on page 8-6 for further details.
Step 2 Choose a Chassis, Module, and ATM Interface from the lists displayed at the left of the window.
Not applicable to Cisco 12000/10720 Router Manager