Cisco 12000 - SRP Interface Status Window-Detailed Description; Interface Tab; Side a Frame; Side B Frame

9-18
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 9 Interface Status
SRP Interface Status
Step 2 Choose a Chassis, Module and SRP Interface from the list boxes displayed on the left side of the
window.
SRP Interface Status Window—Detailed Description
The SRP Interface Status window displays the Interface tab.
Interface Tab
MAC Address—Displays the node MAC address
MAC Passthrough—Displays the status of the MAC Passthrough. If set, the path for the data is available
even if the node is not operational.
Total Nodes On the Ring—Displays the total number of nodes on the ring
Prioirity Threshold—Displays the incoming packet priority limit
IPS Wait To Restore Timer—Displays the time interval (in seconds) for the interface to remain in the
wrap state, after the cause of the wrap is removed.
IPS Lock—Displays the status of the IPS lock (The status of the lock can be on or off)
Note In case of a misconnection at a node (assuming to be the current node), if both the sides of an interface
are incorrectly connected then the problem is at the current node. However, if one side of an interface is
incorrectly connected then the problem is at the remote node connecting to the respective side of the
interface.
Side A Frame
Wrap Status—Displays the status of the Side A Wrap. Is set to wrapped, if Side A wraps.
Misconnection—Displays true, if the Side A of the SRP Interface at the current node is connected to the
Side A of the Interface at the remote host.
Optical Status—Displays the optical status of the Side A Wrap. Applicable only for Cisco 10720 chassis
Side B Frame
Wrap Status—Displays the status of the Side B Wrap. Is set to wrapped, if Side B wraps.
Misconnection—Displays true, if Side B of the Interface at the current node is connected to the Side B
of the Interface at the remote host.
Optical Status—Displays the optical status of the Side B Wrap. Applicable only for Cisco 10720 chassis