13-14
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 13 Managing VLANs
VLAN Configuration
Step 19 Click Finish (when the Deployment Summary information is displayed) to complete deployment and
close the Deployment Wizard - Summary window. The new VLAN object and the sub-interface object
is created and displayed in the Map Viewer window.
Note For managing sub-interface objects, use the same dialogs as those for the interfaces.
Figure 13-18 Example showing the newly deployed Domain, VLAN and Sub-interface
VLAN Configuration
The Configuration window allows you to commission or decommission any VLAN objects in a specific
domain. It also allows the performance logging to be enabled/disabled for the sub-interfaces under a
VLAN object. All the state changes ripple down to the sub-interface child objects.
The VLAN Configuration section provides the following information:
• Viewing the VLAN Configuration Window
• Commissioning a VLAN
• Decommissioning a VLAN
• Start Performance Logging
• Stop Performance Logging
• VLAN Configuration Window—Detailed Description
Viewing the VLAN Configuration Window
To view the VLAN Configuration window, proceed as follows:
Step 1 Right click on a VLAN object in the VLAN view and choose Cisco 12000/10720
Manager>Configuration>VLAN Management>Configuration. See Table 13-1 on page 13-2 for
information on which objects allow you to launch the VLAN Configuration window. The VLAN
Configuration window appears with the Configuration tab displayed.
To Next Page
Loading...
