Cisco 12000 - WRED Tofab Configuration; Creating a Tofab Policy

11-32
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 11 Layer 3 QoS
WRED ToFab Configuration
WRED ToFab Configuration
The WRED ToFab section covers the following areas:
• Creating a ToFab Policy
• Editing an Existing ToFab policy
• Deleting an Existing ToFab policy
• WRED ToFab Policy Configuration Window—Detailed Description
Creating a ToFab Policy
A user can create a WRED ToFab policy and associate the policy to line cards across devices. To create
a ToFab policy under WRED, proceed as follows:
Step 1 Launch the Map Viewer, and choose the Layer3QoSView. Right click on the WRED-MDRR object and
choose Cisco 12000/10720 Manager>Configuration>Module>ToFab>ToFab Configuration to
launch the ToFab Configuration window. Refer Table 11-1 on page 11-2 for information on different
objects that allow you to launch the WRED ToFab Configuration window (see Figure 11-14 on
page 11-33).
Note To associate a ToFab policy to a module, the user must create a CosQ group using the WRED
functionality. See Creating a CoS Queue Group Under WRED for information on creating a
CosQ group.