Cisco 12000 - Viewing the APS Configuration Window

8-19
Cisco 12000/10700 v3.1.1 Router Manager User Guide
OL-4455-01
Chapter 8 Interface Configuration
APS Interface Configuration
Viewing the APS Configuration Window
To view the APS Configuration window, proceed as follows:
Step 1 Right-click on a selected POS line card or POS interface, then choose Cisco 12000/10720
Manager>Configuration>POS>APS Configuration. The APS Configuration window appears:
Figure 8-7 APS Configuration Window—APS Tab
Step 2
Choose a Chassis, Module, and POS Interface from the lists displayed at the left of the window.
The APS Configuration window allows you to:
• Add a working interface
• Remove a working interface
• Add a protected interface
• Remove a protected interface
Note A working and a protected interface cannot be configured at the same time.