Contents
xi
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Configuring the Switch-to-RADIUS-Server Communication 10-13
Enabling Periodic Re-Authentication 10-14
Manually Re-Authenticating a Client Connected to a Port 10-15
Changing the Quiet Period 10-15
Changing the Switch-to-Client Retransmission Time 10-15
Setting the Switch-to-Client Frame-Retransmission Number 10-16
Configuring the Host Mode 10-17
Configuring a Guest VLAN 10-18
Resetting the 802.1x Configuration to the Default Values 10-18
Configuring 802.1x Authentication 10-19
Configuring 802.1x Accounting 10-20
Displaying 802.1x Statistics and Status 10-21
CHAPTER
11 Configuring Interface Characteristics 11-1
Understanding Interface Types 11-1
Access Ports 11-2
Trunk Ports 11-2
Port-Based VLANs 11-3
EtherChannel Port Groups 11-3
Connecting Interfaces 11-4
Using the Interface Command 11-4
Procedures for Configuring Interfaces 11-5
Configuring a Range of Interfaces 11-5
Configuring and Using Interface-Range Macros 11-7
Configuring Ethernet Interfaces 11-8
Default Ethernet Interface Configuration 11-9
Configuring Interface Speed and Duplex Mode 11-10
Configuration Guidelines 11-10
Setting the Interface Speed and Duplex Parameters on a Non-LRE Switch Port 11-12
Setting the Interface Speed and Duplex Parameters on an LRE Switch Port 11-12
Configuring Media Types for Gigabit Ethernet Interfaces on LRE Switches 11-13
Configuring IEEE 802.3z Flow Control on Gigabit Ethernet Ports 11-13
Adding a Description for an Interface 11-14
Monitoring and Maintaining the Interfaces 11-15
Monitoring Interface and Controller Status 11-15
Clearing and Resetting Interfaces and Counters 11-16
Shutting Down and Restarting the Interface 11-17
To Next Page
Loading...
