28-16
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter 28 Configuring SNMP
Displaying SNMP Status
This example shows how to send Entity MIB traps to the host cisco.com. The community string is
restricted. The first line enables the switch to send Entity MIB traps in addition to any traps previously
enabled. The second line specifies the destination of these traps and overwrites any previous
snmp-server host commands for the host cisco.com.
Switch(config)# snmp-server enable traps entity
Switch(config)# snmp-server host cisco.com restricted entity
This example shows how to enable the switch to send all traps to the host myhost.cisco.com using the
community string public:
Switch(config)# snmp-server enable traps
Switch(config)# snmp-server host myhost.cisco.com public
Displaying SNMP Status
To display SNMP input and output statistics, including the number of illegal community string entries,
errors, and requested variables, use the show snmp privileged EXEC command. You can also use the
other privileged EXEC commands in Table 28-5 to display SNMP information. For information about
the fields in the output displays, refer to the Cisco IOS Configuration Fundamentals Command
Reference for Release 12.1.
Table 28-5 Commands for Displaying SNMP Information
Feature Default Setting
show snmp Displays SNMP statistics.
show snmp engineID [local | remote] Displays information on the local SNMP engine and all
remote engines that have been configured on the device.
show snmp group Displays information on each SNMP group on the network.
show snmp user Displays information on each SNMP user name in the
SNMP users table.
To Next Page
Loading...
Need help?
General
