6-12
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter6 Configuring IE2100 CNS Agents
Configuring CNS Embedded Agents
Enabling a Partial Configuration
Beginning in privileged EXEC mode, follow these steps to enable the CNS configuration agent and to
initiate a partial configuration on the switch:
To disable the CNS configuration agent, use the no cns config partial {ip-address | hostname} global
configuration command. To cancel a partial configuration, use the cns config cancel privileged EXEC
command.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cns config partial {ip-address | hostname} [port-number]
[source ip-address]
Enable the configuration agent, and initiate a partial
configuration.
• For {ip-address | hostname}, enter the
IP address or the host name of the configuration
server.
• (Optional) For port-number, enter the port
number of the configuration server. The default
port number is 80.
• (Optional) Enter source ip-address to use for the
source IP address.
Note Though visible in the command-line help
string, the encrypt keyword is not supported.
Step 3
end Return to privileged EXEC mode.
Step 4
show cns config stats
or
show cns config outstanding
Verify information about the configuration agent.
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
To Next Page
Loading...
Need help?
General
