Cisco 2950 - Catalyst Switch User Manual

21-27
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter 21 Configuring IGMP Snooping and MVR
Displaying IGMP Filtering and Throttling Configuration
Displaying IGMP Filtering and Throttling Configuration
You can display IGMP profile characteristics, and you can display the IGMP profile and maximum group
configuration for all interfaces on the switch or for a specified interface. You can also display the IGMP
throttling configuration for all interfaces on the switch or for a specified interface.
Use the privileged EXEC commands in Table 21-8 to display IGMP filtering and throttling
configuration:
Table 21-8 Commands for Displaying IGMP Filtering and Throttling Configuration
show ip igmp profile [profile
number]
Displays the specified IGMP profile or all the IGMP profiles defined on the switch.
show running-configuration
[interface interface-id]
Displays the configuration of the specified interface or the configuration of all interfaces
on the switch, including (if configured) the maximum number of IGMP groups to which
an interface can belong and the IGMP profile applied to the interface.

Cisco 2950 - Catalyst Switch Specifications

General

Forwarding Rate	6.6 Mpps
Jumbo Frame Support	No
Weight	8.8 lbs (4 kg)
RAM	16 MB
Flash Memory	8 MB
Manageable	Yes
Form Factor	Rack-mountable
Ports	24 Ethernet 10/100 ports
Uplink Ports	2 x 10/100/1000Base-T ports
VLANs	250
MAC Address Table Size	8000
Power Supply	100-240 VAC, 50-60 Hz
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Operating Temperature	0 to 40 °C (32 to 104 °F)
Storage Temperature	-25 to 70 °C (-13 to 158 °F)
Operating Humidity	10% to 85% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)