EasyManuals Logo

Cisco 2950 - Catalyst Switch User Manual

Cisco 2950 - Catalyst Switch
710 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #88 background imageLoading...
Page #88 background image
4-10
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter 4 Getting Started with CMS
Displaying CMS
Specifying an HTTP Port (Nondefault Configuration Only)
If you change the HTTP port, you must include the new port number when you enter the IP address in
the browser Location or Address field (for example, http://10.1.126.45:184 where 184 is the new
HTTP port number). You should write down the port number to which you are connected. Use care when
changing the switch IP information.
Configuring an Authentication Method (Nondefault Configuration Only)
If you are not using the default method of authentication (the enable password), you need to configure
the HTTP server interface with the method of authentication used on the switch.
Beginning in privileged EXEC mode, follow these steps to configure the HTTP server interface:
After you have configured the HTTP server interface, display the switch home page, as described in the
“Launching CMS” section on page 4-10.
Displaying CMS
This section provides these topics about displaying CMS:
“Launching CMS” section on page 4-10
“Front Panel View” section on page 4-13
“Topology View” section on page 4-14
Launching CMS
To display the switch home page, follow these steps:
Step 1 Enter the switch IP address in the browser, and press Enter.
Step 2 Enter your username and password when prompted. If no username is configured on your switch (the
default), enter only the enable password (if an enable password is configured) in the password field.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip http authentication {enable | local |
tacacs}
Configure the HTTP server interface for the type of authentication you
want to use.
enableEnable password, which is the default method of HTTP
server user authentication, is used.
local—Local user database, as defined on the Cisco router or access
server, is used.
tacacsTACACS server is used.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify your entries.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2950 - Catalyst Switch and is the answer not in the manual?

Cisco 2950 - Catalyst Switch Specifications

General IconGeneral
Forwarding Rate6.6 Mpps
Jumbo Frame SupportNo
Weight8.8 lbs (4 kg)
RAM16 MB
Flash Memory8 MB
ManageableYes
Form FactorRack-mountable
Ports24 Ethernet 10/100 ports
Uplink Ports2 x 10/100/1000Base-T ports
VLANs250
MAC Address Table Size8000
Power Supply100-240 VAC, 50-60 Hz
Dimensions4.4 cm x 44.5 cm x 24.2 cm
Operating Temperature0 to 40 °C (32 to 104 °F)
Storage Temperature-25 to 70 °C (-13 to 158 °F)
Operating Humidity10% to 85% (non-condensing)
Storage Humidity5% to 95% (non-condensing)

Related product manuals