Name: Cisco 2950 - Catalyst Switch
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

6-7

Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide

78-11380-10

Chapter 6 Configuring IE2100 CNS Agents

Configuring CNS Embedded Agents

Note For more information about running the setup program and creating templates on the Configuration

Registrar, refer to the Cisco Intelligence Engine 2100 Series Configuration Registrar Manual.

Table 6-1 Prerequisites for Enabling Automatic Configuration

Device Required Configuration

Access switch Factory default (no configuration file)

Distribution switch

• IP helper address

• Enable DHCP relay agent

• IP routing (if used as default gateway)

DHCP server

• IP address assignment

• TFTP server IP address

• Path to bootstrap configuration file on the TFTP server

• Default gateway IP address

TFTP server

• Create a bootstrap configuration file that includes the CNS

configuration commands that enable the switch to

communicate with the IE2100 Configuration Registrar.

• Configure the switch to use either the switch MAC address or

the serial number (instead of the default host name) to

generate the configID and eventID.

• Configure the CNS event agent to push the configuration file

to the switch.

IE2100 Configuration Registrar Create one or more templates for each type of device, and map the

configID of the device to the template.

Questions and Answers:

Need help?

Do you have a question about the Cisco 2950 - Catalyst Switch and is the answer not in the manual?

Cisco 2950 - Catalyst Switch Specifications

General