Cisco 2950 - Catalyst Switch User Manual

7-20
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter 7 Clustering Switches
Creating a Switch Cluster
For additional authentication considerations in switch clusters, see the “TACACS+ and RADIUS”
section on page 7-16.
Figure 7-10 Add to Cluster Window
Figure 7-11 Using the Topology View to Add Member Switches
Enter the password of
the candidate switch. If
no password exists for
the switch, leave this
field blank.
Select a switch, and click
Add. Press Ctrl and left-
click to select more than
one switch.
2900-LRE-24-1
65724
Thin line means a
connection to a
candidate switch.
Right-click a candidate
switch to display the
pop-up menu, and select
Add to Cluster to add
the switch to the cluster.
65725

Cisco 2950 - Catalyst Switch Specifications

General

Forwarding Rate	6.6 Mpps
Jumbo Frame Support	No
Weight	8.8 lbs (4 kg)
RAM	16 MB
Flash Memory	8 MB
Manageable	Yes
Form Factor	Rack-mountable
Ports	24 Ethernet 10/100 ports
Uplink Ports	2 x 10/100/1000Base-T ports
VLANs	250
MAC Address Table Size	8000
Power Supply	100-240 VAC, 50-60 Hz
Dimensions	4.4 cm x 44.5 cm x 24.2 cm
Operating Temperature	0 to 40 °C (32 to 104 °F)
Storage Temperature	-25 to 70 °C (-13 to 158 °F)
Operating Humidity	10% to 85% (non-condensing)
Storage Humidity	5% to 95% (non-condensing)