Cisco 2950 - Catalyst Switch

Contents
xvii
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Configuring the VMPS Client 17-28
Entering the IP Address of the VMPS 17-28
Configuring Dynamic Access Ports on VMPS Clients 17-28
Reconfirming VLAN Memberships 17-29
Changing the Reconfirmation Interval 17-29
Changing the Retry Count 17-30
Monitoring the VMPS 17-30
Troubleshooting Dynamic Port VLAN Membership 17-31
VMPS Configuration Example 17-31
CHAPTER 18 Configuring VTP 18-1
Understanding VTP 18-1
The VTP Domain 18-2
VTP Modes 18-3
VTP Advertisements 18-3
VTP Version 2 18-4
VTP Pruning 18-4
Configuring VTP 18-6
Default VTP Configuration 18-6
VTP Configuration Options 18-7
VTP Configuration in Global Configuration Mode 18-7
VTP Configuration in VLAN Configuration Mode 18-7
VTP Configuration Guidelines 18-8
Domain Names 18-8
Passwords 18-8
Upgrading from Previous Software Releases 18-8
VTP Version 18-9
Configuration Requirements 18-9
Configuring a VTP Server 18-9
Configuring a VTP Client 18-11
Disabling VTP (VTP Transparent Mode) 18-12
Enabling VTP Version 2 18-13
Enabling VTP Pruning 18-14
Adding a VTP Client Switch to a VTP Domain 18-14
Monitoring VTP 18-16