Cisco 2950 - Catalyst Switch

Contents
xxii
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
CHAPTER 27 Configuring System Message Logging 27-1
Understanding System Message Logging 27-1
Configuring System Message Logging 27-2
System Log Message Format 27-2
Default System Message Logging Configuration 27-3
Disabling and Enabling Message Logging 27-4
Setting the Message Display Destination Device 27-4
Synchronizing Log Messages 27-6
Enabling and Disabling Timestamps on Log Messages 27-7
Enabling and Disabling Sequence Numbers in Log Messages 27-8
Defining the Message Severity Level 27-8
Limiting Syslog Messages Sent to the History Table and to SNMP 27-10
Configuring UNIX Syslog Servers 27-11
Logging Messages to a UNIX Syslog Daemon 27-11
Configuring the UNIX System Logging Facility 27-11
Displaying the Logging Configuration 27-13
CHAPTER 28 Configuring SNMP 28-1
Understanding SNMP 28-1
SNMP Versions 28-2
SNMP Manager Functions 28-3
SNMP Agent Functions 28-4
SNMP Community Strings 28-4
Using SNMP to Access MIB Variables 28-4
SNMP Notifications 28-5
Configuring SNMP 28-5
Default SNMP Configuration 28-6
SNMP Configuration Guidelines 28-6
Disabling the SNMP Agent 28-7
Configuring Community Strings 28-7
Configuring SNMP Groups and Users 28-9
Configuring SNMP Notifications 28-11
Setting the Agent Contact and Location Information 28-14
Limiting TFTP Servers Used Through SNMP 28-14
SNMP Examples 28-15
Displaying SNMP Status 28-16