Name: Cisco 2950 - Catalyst Switch
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

21-20

Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide

78-11380-10

Chapter 21 Configuring IGMP Snooping and MVR

Configuring MVR

To return the interface to its default settings, use the no mvr [type | immediate | vlan vlan-id | group]

interface configuration commands.

This example shows how to configure a port as a receiver port, statically configure the port to receive

multicast traffic sent to the multicast group address, configure Immediate Leave on the interface, and

verify the results.

Switch(config)# mvr

Switch(config)# interface gigabitethernet0/1

Switch(config-if)# mvr type receiver

Switch(config-if)# mvr vlan 22 group 228.1.23.4

Switch(config-if)# mvr immediate

Switch(config)# end

Switch# show mvr interface gigabitethernet0/1

Type: RECEIVER Status: ACTIVE Immediate Leave: ENABLED

Step 6

mvr immediate (Optional) Enable the Immediate Leave feature of MVR on the port.

Note This command applies to only receiver ports and should only be

enabled on receiver ports to which a single receiver device is

connected.

Step 7

end Return to privileged EXEC mode.

Step 8

show mvr

show mvr interface

show mvr members

Verify the configuration.

Step 9

copy running-config startup-config (Optional) Save your entries in the configuration file.

Command Purpose

Questions and Answers:

Need help?

Do you have a question about the Cisco 2950 - Catalyst Switch and is the answer not in the manual?

Cisco 2950 - Catalyst Switch Specifications

General