Cisco 2950 - Catalyst Switch

Index
IN-4
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
BPDU
error-disabled state
16-2
filtering 16-3
RSTP format 15-9
BPDU filtering
described
16-3
enabling 16-15
support for 1-5
BPDU guard
described
16-2
enabling 16-14
support for 1-5
broadcast storm control
configuring
22-2
disabling 22-4
browser configuration 7-1
C
cables, monitoring for unidirectional links 23-1
candidate switch
adding
7-19
automatic discovery 7-5
defined 7-4
HC 7-21
passwords 7-19
requirements 7-4
standby group 7-21
See also command switch, cluster standby group, and
member switch
Catalyst 2955
configuring alarm profiles
attaching an alarm profile to a port
3-10
creating or modifying alarm profiles 3-9
configuring switch alarms 3-1 to 3-11
configuring the FCS bit error rate alarm
setting the FCS error hysteresis threshold
3-8
setting the FCS error threshold 3-8
Catalyst 2955 (continued)
configuring the power supply alarm
setting the power mode
3-4, 3-5
setting the power supply alarm options 3-5
configuring the temperature alarms
associating the temperature alarms to a relay
3-7
setting a secondary temperature threshold 3-6
default alarm configuration 3-4
displaying Catalyst 2955 switch alarms 3-11
enabling SNMP traps 3-11
FCS error hysteresis threshold 3-2
global status monitoring alarms
power supply alarm
3-2
temperature alarm 3-2
port status monitoring alarms
FCS bit error rate alarm
3-3
link fault alarm 3-3
port is not operating alarm 3-3
port not forwarding alarm 3-3
triggering alarm options
configurable relays
3-3
FCS Bit Error Rate alarm 3-3
methods to trigger 3-3
SNMP traps 3-4
syslog messages 3-4
caution, described xxx
CC (command switch) 7-21
CDP
and trusted boundary
30-24
automatic discovery in switch clusters 7-5
configuring 24-2
default configuration 24-2
described 24-1
disabling for routing device 24-3, 24-4
enabling and disabling
on an interface
24-4
on a switch 24-3
monitoring 24-5
overview 24-1