Cisco 2950 - Catalyst Switch - Page 703

Index
IN-27
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Stack Membership Discovery Protocol 16-6
Standby Command Configuration window 7-22
standby command switch
configuring
7-21
considerations 7-12
defined 7-2
priority 7-11
requirements 7-3
virtual IP address 7-12
See also cluster standby group and HSRP
standby group, cluster
See cluster standby group and HSRP
startup configuration
booting
manually
5-13
specific image 5-13
clearing B-19
configuration file
automatically downloading
5-12
specifying the filename 5-12
default boot configuration 5-12
static access ports
assigning to VLAN
17-11
defined 11-2, 17-3
static addresses
See addresses
static VLAN membership
17-2
statistics
802.1x
10-21
CDP 24-5
interface 11-15
QoS ingress and egress 30-39
RMON group Ethernet 26-5
RMON group history 26-5
SNMP input and output 28-16
VTP 18-16
sticky learning
configuration file
22-7
defined 22-7
disabling 22-7
enabling 22-7
saving addresses 22-7
storm control
described
22-2
displaying 22-13
STP
accelerating root port selection
16-4
BackboneFast
described
16-9
enabling 16-18
BPDU filtering
described
16-3
enabling 16-15
BPDU guard
described
16-2
enabling 16-14
BPDU message exchange 14-3
configuration guidelines 14-12, 16-13
configuring
forward-delay time
14-22
hello time 14-21
in cascaded stack 14-23
maximum aging time 14-22
path cost 14-19
port priority 14-17
root switch 14-14
secondary root switch 14-16
spanning-tree mode 14-13
switch priority 14-20
counters, clearing 14-24
cross-stack UplinkFast
described
16-5
enabling 16-17
default configuration 14-11
default optional feature configuration 16-13