Cisco 4500M Command Reference

2-109
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
interface range
Valid values for interface-type are as follows:
• FastEthernet
• GigabitEthernet
• Vlan vlan_id
You cannot specify both a macro and an interface range in the same command. After creating a macro,
you can enter additional ranges. Likewise, if you have already entered an interface range, the CLI does
not allow you to enter a macro.
You can specify a single interface in the port-range value. This makes the command similar to the
interface interface-number command.
Examples This example shows how to use the interface range command to interface to FE 5/18 - 20:
Switch(config)# interface range fastethernet 5/18 - 20
Switch(config-if)#
This command shows how to run a port-range macro:
Switch(config)# interface range macro macro1
Switch(config-if)#
Related Commands define interface-range
show running config (refer to Cisco IOS documentation)

Cisco 4500M Specifications

General

Brand	Cisco
Model	4500M
Category	Network Router
Language	English