EasyManuals Logo

Cisco 4500M Command Reference

Cisco 4500M
578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #528 background imageLoading...
Page #528 background image
2-496
Catalyst4500 Series SwitchCiscoIOS Command Reference—Release 12.2(18)EW
78-16201-01
Chapter2Cisco IOS Commands for the Catalyst 4500 Series Switches
vlan (VLAN Database mode)
Defaults The defaults are as follows:
The vlan-name is “VLANxxxx” where “xxxx” represents four numeric digits (including leading
zeroes) equal to the VLAN ID number.
The media type is Fast Ethernet.
The state is active.
The said-value is 100,000 plus the VLAN ID number.
The mtu-size default is dependent upon the VLAN type:
fddi—1500
trcrf—1500 if V2 is not enabled; 4472 if it is enabled
fd-net—1500
trbrf—1500 if V2 is not enabled; 4472 if it is enabled
No ring number is specified.
No bridge number is specified.
No parent VLAN is specified.
No STP type is specified.
No translational bridge VLAN is specified.
Command Modes VLAN configuration
Command History
Usage Guidelines VLAN 1 parameters are factory configured and cannot be changed.
When you define vlan-name, the name must be unique within the administrative domain.
The SAID is documented in 802.10. When the no form is used, the VLANs SAID is returned to the
default.
When you define the said-value, the name must be unique within the administrative domain.
The bridge bridge-number argument is used only for Token Ring-net and FDDI-net VLANs and is
ignored in other types of VLANs. When the no form is used, the VLANs source-route bridging number
returns to the default.
The parent VLAN resets to the default if the parent VLAN is deleted or the media keyword changes the
VLAN type or the VLAN type of the parent VLAN.
The tb-vlan1 and tb-vlan2 are used to configure translational bridge VLANs of a specified type of VLAN
and are not allowed in other types of VLANs. Translational bridge VLANs must be a different VLAN
type than the affected VLAN; if two VLANs are specified, the two must be different VLAN types.
A translational bridge VLAN will reset to the default if the translational bridge VLAN is deleted or the
media keyword changes the VLAN type or the VLAN type of the corresponding translational bridge
VLAN.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.

Table of Contents

Other manuals for Cisco 4500M

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4500M and is the answer not in the manual?

Cisco 4500M Specifications

General IconGeneral
BrandCisco
Model4500M
CategoryNetwork Router
LanguageEnglish

Related product manuals