Procedure
Step 1
Open a CLI.
Step 2
Enter the following command to enter debug mode:
debugsh
Step 3
Enter ? to see all available commands and options.
Step 4
Use the applicable commands and options to find the desired KEM information.
Step 5
To exit debug mode, press Ctrl-C.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
77
Cisco Unified IP Color Key Expansion Module Setup
Troubleshoot the KEM
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
