DescriptionFormat
Eight sets of hexadecimal digits separated by colons. Leading or trailing
zeros in each group may be omitted.
Example: 2001:db8:0:0:0:52:0:1
X:X:X:X:X:X:X:X
Collapse a single run of consecutive zero groups into a single group
represented by a double colon.
Example: 2001:db8::52:0:1
Compressed
•
To enter a colon (:) in the address, press the asterisk (*) on the keypad.
•
To enter hexadecimal digits a, b, and c, press 2 on the keypad, scroll to select the required digit, and
press Enter.
•
To enter hexadecimal digits d, e, and f, press 3 on the keypad, scroll to select the required digit, and
press Enter.
•
After you enter each part of the address, you press Apply or Revert .
Step 5
Change toggle fields using these steps:
a) If an option is set to No, press Yes to enable it. If the option is set to Yes, press No to disable it.
b) Press Apply to save your change, or Revert to discard it.
Step 6
Press Apply to save your change or press Revert to discard the change.
Edit Wireless IPv6 Setup options
This procedure only applies to the Cisco Unified IP Phone 9971 when Wi-Fi is enabled on the Cisco Unified
Communications Manager.
If DHCPv6 Enabled is set to Yes, some IPv6 Setup menu options cannot be edited. If you need to change
a setting and it is not available, check the value of the DHCPv6 Enabled option.
Note
Procedure
Step 1
Press Applications.
Step 2
Select Administrator Settings > Network Setup > Wireless Setup > WLAN IPv6 Setup.
Step 3
Select the option to edit or to toggle.
Step 4
To enter IPv6 addresses,
a) Click in an input field.
b) Make your changes to the field (see the information below).
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0 (SIP)
122
Cisco Unified IP Phone Settings
Edit Wireless IPv6 Setup options
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
Need help?
General
