Cisco 8961 - 802.1 X Authentication and Transaction Status; 802.1 X Authentication Options; Access 802.1 X Authentication

To changeDescriptionOption
For more information about these settings,
see the “Configuring the Cisco CTL Client”
section in the Cisco Unified
Communications Manager Security Guide.
Common name of the CAPF that
the phone uses. Also displays a
certificate icon if a certificate is
installed for this server.
CAPF Server
For more information about these settings,
see the “Configuring the Cisco CTL Client”
section in the Cisco Unified
Communications Manager Security Guide.
IP address of the trusted SRST
router that is available to the phone,
if such a device is configured in
Cisco Unified Communications
Manager Administration. Also
displays a certificate icon if a
certificate is installed for this
server.
SRST Router
802.1X Authentication and Transaction Status
The 802.1X Authentication Settings menu allows you to enable 802.1X authentication and view transaction
status.
Access 802.1X Authentication
You can access the 802.1X authentication settings by following these steps:
Procedure
Step 1
Press Applications .
Step 2
Choose Administrator Settings > Security Setup > 802.1X Authentication.
Step 3
Configure the options as described in 802.1X Authentication Options, on page 125.
Step 4
To exit this menu, press Exit.
802.1X Authentication Options
The following table describes the 802.1X authentication options.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
125
Cisco Unified IP Phone Settings
802.1X Authentication and Transaction Status
REVIEW DRAFT - CISCO CONFIDENTIAL