Call Forward Notification Setup
You set up the information that the user sees from Cisco Unified Communications Manager Administration
in the Device Configuration window (Device > Phone). The following table describes the Call Forward
Notification fields.
Table 28: Call Forward Notification Fields
DescriptionField
When this check box is checked, the caller name displays in the notification
window.
By default, this check box is checked.
Caller Name
When this check box is checked, the caller number displays in the notification
window.
By default, this check box is not checked.
Caller Number
When this check box is checked, the information about the caller who last
forwarded the call displays in the notification window.
Example: If Caller A calls B, but B has forwarded all calls to C and C has
forwarded all calls to D, the notification box that D sees contains the phone
information for caller C.
By default, this check box is not checked
Redirected Number
When this check box is checked, the information about the original recipient of
the call displays in the notification window.
Example: If Caller A calls B, but B has forwarded all calls to C and C has
forwarded all calls to D, then the notification box that D sees contains the phone
information for caller B.
By default, this check box is checked.
Dialed Number
Client Matter Codes Setup
To force users to enter a Client Matter Code (CMC) when placing a call, configure the fields in the Client
Matter Code Configuration window (Call Routing > Client Matter Codes). The following table describes
the Client Matter Code field.
Table 29: CMC Field
DescriptionField
This check box controls whether the system prompts the user for a CMC upon
placing a call.
Require Client Matter
Code
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
185
Features, Templates, Services, and User Setup
Call Forward Notification Setup
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
Need help?
General
