Cisco 8961 - Set Wireless Field; Set Wireless Sign in Access Field

To changeDescriptionOption
See Set 802.11 Mode Field, on page
112.
Specifies the wireless signal standard that is
used in the WLAN. Valid values specify:
•
Auto: Default value. Gives precedence
to 5.0 Ghz if available.
•
802.11a
•
802.11b/g
802.11 Mode
Notes
Consider the following when you select AKM:
1
AKM uses LEAP for 802.1x when WPA, WPA2, or CCKM is in use.
2
AKM selects the encryption method by giving precedence to the strongest key management type and then
the strongest cipher.
3
CCKM is not supported with WPA2.
Related Topics
Display Setup Menu, on page 102
Value Input Guidelines, on page 103
Set Wireless Field
Procedure
Step 1
Scroll to the Wireless option, and use the toggle switch to change the setting between on and off.
Step 2
Press Apply.
Set Wireless Sign in Access Field
Procedure
Step 1
Scroll to the Wireless Sign In option, and use the toggle switch to change the setting between on and off.
Step 2
Press Apply.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
111
Cisco Unified IP Phone Settings
Set Wireless Field
REVIEW DRAFT - CISCO CONFIDENTIAL