Cisco 8961 Administration Guide

CHAPTER 7
Cisco Unified IP Phone Settings
The Cisco Unified IP Phone includes many configurable network settings that you may need to modify
before the phone is functional for your users. You can access these settings, and change some of them,
through menus on the phone. You configure settings that are display-only on the phone in Cisco Unified
Communications Manager Administration.
This chapter includes the following topics:
•
Cisco Unified IP Phone Setup Menus, page 101
•
Ethernet Setup menu, page 104
•
Wireless Setup menu, page 108
•
IPv4 Setup Menu Options, page 113
•
IPv6, page 119
•
Security Setup Menu, page 123
Cisco Unified IP Phone Setup Menus
The Cisco Unified IP Phone includes the following configuration menus:
•
Network Setup: Provides options for viewing and configuring network settings such as IPv4, IPv6,
WLAN, and Ethernet.
◦
Ethernet Setup: The menu items in this submenu provide configuration options to configure the
Cisco Unified IP Phone over an ethernet network.
◦
Wireless Setup: The menu items in this submenu provide configuration options to configure the
Cisco Unified IP Phone with the wireless local area network (WLAN).
The Wireless Setup menu only displays on the Cisco Unified IP Phone 9971 when Wi-Fi
is enabled on the Cisco Unified Communications Manager.
Note
◦
IPv4 Setup and IPv6 Setup: These submenus of the Ethernet Setup menu and of the Wireless Setup
menu provide additional network options.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
101

Cisco 8961 Specifications

General

Resolution	640 x 480 pixels
Display	5-inch TFT color display
Ethernet	10/100/1000 Mbps
Power	IEEE 802.3af Power over Ethernet (PoE) Class 3
Connectivity	Two-port Gigabit Ethernet switch
Buttons	4 softkeys
USB Port	Yes, supports USB 2.0
Headset Jack	Yes, dedicated headset port
Speakerphone	Full-duplex speakerphone
Codec Support	G.711, G.722, G.729, iLBC
Security	802.1X authentication, TLS, SRTP, HTTPS