Configuration ReferenceDescriptionFeature
For more information, see “Cisco Unified
Mobility” chapter in the Cisco Unified
Communications Manager Features and
Services Guide.
Reroutes an enterprise originated call that was placed
a user’s mobile phone through the enterprise number.
The call only rings the user mobile but not the desk
phone. When the user answers the call on the mobile
phone, the desk phone displays a Remote in Use
message. During these calls, a user can use the various
features of the mobile phone.
Intelligent Session Control
For more information, see IPv6.Provides support for expanded IP addressing on Cisco
IP Phones. IPv6 support is provided in standalone or in
dual-stack configurations. In dual-stack mode, the phone
is able to communicate using IPv4 and IPv6
simultaneously, independent of the content.
IPv6 Support
For more information, see the option
“Always use prime line” in the following
chapters of the Cisco Unified
Communications Manager
Administration Guide:
• “Device Profile Configuration”
• “Common Phone Profile
Configuration”
• “Cisco Unified IP Phone Services
Configuration”
If this feature is disabled (default), the ringing line is
selected. When the feature is enabled, the primary line
is picked up even if a call is ringing on another line.
The user must manually select the other line.
This feature can also be enabled or disabled
for Extension Mobility.
Note
Line Select
For more information, see the option
“Always use prime line for voice
message” in the following chapters of the
Cisco Unified Communications Manager
Administration Guide:
• “Device Profile Configuration”
• “Common Phone Profile
Configuration”
• “Cisco Unified IP Phone Services
Configuration”
When disabled (default), pressing the Messages button
selects the line that has a voice message. If more than
one line has voice mail, the first available line is
selected. When the features is enabled, the primary line
is always used to retrieve voice messages.
This feature can also be enabled or disabled
for Extension Mobility.
Note
Line Select for Voice Messages
For more information, see Cisco Unified
Communications Manager
Administration Guide.
Enables users to see if a Cisco Unified IP Phone is in
the Remote-in-use state when there is a call alert on
shared lines.
Line State Display Enhancement
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
(SIP)
149
Features, Templates, Services, and User Setup
Telephony features available for Cisco Unified IP Phone
REVIEW DRAFT - CISCO CONFIDENTIAL
To Next Page
Loading...
